Bricalo
English ▾

Bricalo › Drywall calculator

Drywall calculator

Work out how many sheets of drywall (plasterboard) and screws you need for a wall or partition.

Results

Sheets needed4
Surface to cover112sq ft
Drywall screws (approx.)120

Drywall sheets by wall length

8 ft walls, one side, 4×8 sheets, 10% waste.

Wall lengthWall heightSurface to coverSheets needed
8 ft8 ft64 sq ft3
10 ft8 ft80 sq ft3
12 ft8 ft96 sq ft4
14 ft8 ft112 sq ft4
16 ft8 ft128 sq ft5

How to use the drywall calculator

  1. Enter the length and height of the wall. For a whole room, add up the length of all walls.
  2. Choose whether you cover one side or both sides of a stud partition.
  3. Subtract the openings (doors, windows) if they’re large.
  4. Pick your sheet size and a waste margin.

How it’s calculated

Area = length × height × sides − openings

Sheets = area × (1 + waste) ÷ sheet area, rounded up.

Screws are estimated at about 11 per m² (1 per sq ft), rounded up to the nearest 10.

Example: a 4 m long, 2.5 m high wall covered on one side is 10 m². With 120 × 250 cm boards (3 m²) and 10% waste, you need 4 boards and about 110 screws.

Tips

  • Hang ceiling boards first, then walls, with boards on the walls running horizontally or vertically depending on your local practice.
  • Use moisture-resistant (green) board in bathrooms and kitchens.
  • Don’t forget joint tape and joint compound: roughly 1 kg of compound per m² (0.2 lb per sq ft) for taping and finishing.

Also useful for this project: paint calculator and room area calculator.

Frequently asked questions

How many sheets of drywall for a 12×8 wall?

A 12×8 ft wall is 96 sq ft. With 4×8 sheets (32 sq ft) you need 3 sheets, or 4 with a 10% waste margin. A partition covered on both sides needs twice as many.

Should I use 4×8 or 4×12 sheets?

Longer sheets mean fewer joints to tape and a flatter finish, but they are heavy and hard to carry alone. 4×8 is the easiest choice for DIY; 4×12 is faster for large walls with a helper.

How many screws per sheet of drywall?

About 32 screws for a 4×8 sheet on walls (every 12 in on studs spaced 16 in apart), a bit more on ceilings. The calculator estimates around 1 screw per square foot.

How much waste should I plan?

10% is a good default. Use 15% for rooms with many openings, angles or sloped ceilings.

More calculators